logo
TSB report on remote Labrador helicopter crash says pilot attempted to land on ice in low visibility

TSB report on remote Labrador helicopter crash says pilot attempted to land on ice in low visibility

CBC25-03-2025

A helicopter pilot was trying to make a precautionary landing on a frozen lake in remote Labrador during bad winter weather when they crash landed in May 2024.
That's the conclusion of a Transportation Safety Board of Canada (TSB) investigation into a helicopter collision on Lewis Lake, about 50 kilometres southwest of Postville, on Labrador's north coast.
The pilot — who was the only person travelling in the Custom Helicopters aircraft — had planned to fly from Happy Valley-Goose Bay in central Labrador, to Nunavut to participate in the Polar Continental Shelf Program's scientific research.
The pilot arrived at the Goose Bay Airport on April 28, according to the TSB report, and for each of the next three days had planned to fly the 860-nautical-mile route, but each day felt the conditions weren't suitable.
Finally, on May 2, he changed his mind and took to the air despite reduced visibility and cloud ceilings due to a light snowfall.
The pilot flew toward Hopedale at a reduced speed after determining conditions would improve along the Labrador coast.
Visibility decreased as the pilot headed toward Postville, so he made a 180-degree turn southwest. When visibility decreased once again after an attempt to head closer toward his destination, he made another 180-degree turn.
WATCH | Video from May 2024 shows helicopter wreckage:
A helicopter crashed upside down in a frozen lake — and the pilot survived
11 months ago
Duration 0:23
A pilot was hoisted to safety after his helicopter crashed about 180 kilometres north of Goose Bay, N.L. on May 2. Video of the aftermath, posted by the Halifax Joint Rescue Coordination Centre, shows the helicopter upside down and the inside filled with snow. The pilot suffered minor injuries.
That's when the pilot found himself near a frozen Lewis Lake, and tried to make a precautionary landing, the report said.
"The poor visibility caused the pilot to misjudge his height above ground in the descent," the TSB report reads. "The helicopter struck the frozen surface of Lewis Lake [...] while travelling parallel to, and about 700 feet from, the north shoreline of the lake."
The helicopter rolled upside down after hitting the ice.
Safety and survival
The helicopter pilot was operating a visual flight rules flight, meaning he depended primarily on eyesight and clear conditions for navigation. He also used navigation charts displayed on a tablet app.
"The aircraft had a Sentry Plus portable automatic dependent surveillance-broadcast receiver on board that incorporated a global positioning system receiver and an attitude and heading reference system; however, the pilot did not turn it on or pair it to the tablet," the report said.
According to Transport Canada, aircraft from the Manitoba-based Custom Helicopters are allowed to operate in some reduced-visibility conditions. Its procedures direct pilots not to fly over snow or ice-covered surfaces with "poor visual reference to the ground."
The helicopter's landing gear skids, rotor assembly and tail boom were all heavily damaged on impact, and its windscreens and chin bubbles were shattered.
The pilot was picked up by search and rescue crews around 3:30 p.m. on May 2, and changed from his wet clothes to dry clothes while taking shelter in the wreckage as he waited. He only had minor injuries.
The TSB report said Custom Helicopters developed training scenarios for visual flight rules, and the board made recommendations to pilots heading on similar journeys.
"Pilots are reminded to plan ahead, consider strategies to avoid adverse weather, and have alternate plans should such weather be encountered."

Orange background

Try Our AI Features

Explore what Daily8 AI can do for you:

Comments

No comments yet...

Related Articles

The Manitoba designer breaking barriers to create traditional Indigenous clothing
The Manitoba designer breaking barriers to create traditional Indigenous clothing

CTV News

timean hour ago

  • CTV News

The Manitoba designer breaking barriers to create traditional Indigenous clothing

A Manitoba designer is honouring his culture and defying gender stereotypes through the creation of traditional Indigenous fashion. Tyler Moody, 28, is a fashion designer and youth advocate from Nisichawayasihk Cree Nation, also known as Nelson House. The Rocky Cree designer's journey began six months ago while working as a cultural support worker for a non-profit Indigenous organization. When Moody, who had never used a sewing machine before, created a ribbon skirt as part of this job, he discovered a newfound talent. 'It took me about four hours to make my first ribbon skirt, and it was beautiful. I was very impressed. Everyone else was impressed,' he said. 'I've never seen a man sew before, so I'm happy I'm able to take this role to make these designs and create something that you don't see coming from a man.' Though Moody's career in fashion has only just begun, he's already making an impact and inspiring those around him. Where it began Moody's story begins in northern Manitoba—more than 800 kilometres away from his current home of Winnipeg. He said he grew up in the bush, where he hunted, fished and spent time out on the land. However, Moody's childhood involved many hardships as well, as he was exposed to alcoholism and drug use. He also had to help raise his siblings from a young age. 'It was very hard growing up. It was challenging to even try to get to school or things like that,' he said. 'But I always pushed my siblings. I always made sure that they ate and things like that… I risked a lot growing up, but I was grateful enough that I was able to make it happen.' Despite these challenges, Moody was able to break these generational cycles and move away from his community, even spending some time living in South Korea. He said his upbringing contributed to his success because it showed him that anything is possible no matter what you've been through. 'I decided to break those cycles and those intergenerational traumas and just healing, not just myself but a whole generation—a new generation for my Moody side of my family,' he said. What he creates In his first six months as a designer, Moody has been making ribbon skirts—a cultural garment for Indigenous women that represents identity, heritage and strength. His design process involves picking out a fabric and colours, creating cutouts and layouts, and sewing it all together. Moody said each skirt takes him a few hours, depending on the details and sizing. 'The more ribbons you add, the more work that is,' he said. 'The bigger it is, the harder it is. It just depends on how big you want it.' Moving forward, Moody wants to expand his offerings to traditional menswear, as well as regalia and jingle dresses. Tyler Moody A black silk LGBTQIA+ ribbon skirt is featured in this image. (Tyler Moody/Facebook) Why he loves to design Moody said his love for sewing and design comes from its therapeutic nature. He added the work helps to stop him from overthinking and calms him down. 'Just seeing a finished product that I made with my own hands really helps me see the visions that I see for my future self, and it really does inspire me to make these pieces,' he said. Moody, who has a TikTok following of more than 110,000, said he also enjoys the way his work is able to impact and inspire others. He noted he's received plenty of positive feedback and is proud to be representing his culture across the world. 'I pretty much made my own journey, my own life story, within these years, and I'm grateful that I was able to share it across Turtle Island… No matter where I am in this world, I will always represent where I came from.' Tyler Moody One of Moody's colourful skirts is featured in this supplied image. (Tyler Moody) Spotlight from Marshall Fabrics Moody was recently spotlighted as part of Marshall Fabrics' designer feature, which aims to celebrate those who shop at the store. Marshall Fabrics retail manager Erin Kembel said local designers like Moody make up the bulk of the store's customers and help to sustain the retailer's success. She added that they wanted to feature Moody because they are impressed by the work he is doing. 'We just loved what he is doing to celebrate his community and the work he was doing and just how ambitious he is,' she said. Currently, Moody's receiving lots of orders, including people wanting him to make them wedding dresses. '[My work] started off very little. I did not know what I was doing, but I started getting better and better every month,' he said. 'People have seen how much I have grown within the six months I've now been sewing.'

Fire forces closure of Gimli landfill
Fire forces closure of Gimli landfill

CTV News

timea day ago

  • CTV News

Fire forces closure of Gimli landfill

A map showing the location of the Arnes Landfill in the RM of Gimli. (CTV News Winnipeg) A fire in the RM of Gimli closed down a landfill in the community. According to a public notice, crews responded to the fire at Arnes Landfill around 4 a.m. on Thursday. Firefighters were on scene throughout the day working to extinguish the blaze. The landfill was closed to the public on Thursday and may be closed again on Friday. CTV News reached out to the RM of Gimli for an update.

DOWNLOAD THE APP

Get Started Now: Download the App

Ready to dive into a world of global content with local flavor? Download Daily8 app today from your preferred app store and start exploring.
app-storeplay-store